JN0-360.Examcollection.premium.Exam.322q
.pdfCorrect Answer: D
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 276
Click the Exhibit button.
Referring to the exhibit, all interswitch links are configured as trunks supporting all VLANs. Host A sends a frame with an unknown destination MAC address to S2.
Which switches will receive this frame?
A.S1, S3 and S4
B.S1 only
C.S1 and S3 only
D.S1 and S4 only
Correct Answer: C
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 277
Which table will a Junos-based MPLS ingress router first consult to determine the next hop for BGP routes reachable through an LSP?
A. inet.1
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
B.mpls.0
C.inet.3
D.inet.0
Correct Answer: D
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 278
Which Layer 2 mechanism logically groups network nodes into separate broadcast domains?
A.IS-IS levels
B.OSPF areas
C.VLAN
D.IP subnets
Correct Answer: C
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 279
Click the Exhibit button.
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
Switch 1 and Switch 2 are configured to run MSTP. However, MSTP is not working.
Referring to the exhibit, which two actions will correct the problem? (Choose two.)
A.Configure interface ge-0/0/2 on Switch 2
B.Correct the bridge-priority parameter to be identical on both switches.
C.Configure revision-level 2 on Switch 1.
D.Correct the configuration-name parameter to be identical on both switches.
Correct Answer: CD
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 280
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
You are asked to configure a new LSP in your network. The new LSP must take a specific path using a given set of routers.
What must you do to accomplish this task?
A.A named path must be defined and referenced as primary for the LSP.
B.A named path must be defined and referenced as preferred for the LSP.
C.A named path must be defined and given a low priority.
D.A named path must be defined and given a high priority.
Correct Answer: A
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 281
Which three IPv6 addresses are valid equivalents for the address 2001:0000:0000:0000:0134:fc0e:cc8b:458a? (Choose three?)
A.2001:134:fc0e:cc8b:458a
B.2001:0:0:0:0134:fc0e:cc8b:458a
C.2001:0:0:0134:fc0e:cc8b:458a
D.2001::134:fc0e:cc8b:458a
E.2001:0::0:134:fc0e:cc8b:458a
Correct Answer: BDE
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 282
Click the Exhibit button.
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
In the exhibit, R1, R2, and R3 are all IBGP peers within AS 65505. R1 receives a BGP advertisement from an external BGP peer in AS 65555, and BGP advertisement from R3. The default BGP advertisement behavior is in effect in this environment.
In this scenario, which two statements are true? (Choose two.)
A.R1 will advertise the route received from R3 to R2 and its external BGP peer.
B.R1 will advertise the route received from R3 only to its external BGP peer.
C.R1 will advertise the route received from its external peer to R2 and R3.
D.R1 will not advertise the route received from its external peer to R2 or R3.
Correct Answer: BC
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 283
Which three statements are true about GRE and IP-IP tunnels? (Choose three.)
A.All intermediary devices must have reachability to the tunnel endpoints.
B.Tunnel endpoints must use the loopback interface for reachability.
C.Tunnel endpoints must have a route that directs traffic into the tunnel.
D.Tunnel endpoints must have a route to the remote endpoint learned by a dynamic routing protocol.
E.Tunnel endpoints require a tunnel interface.
Correct Answer: ACE
Section: Volume C
Explanation
Explanation/Reference:
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
QUESTION 284
Which two statements are correct about a generated route? (Choose two.)
A.A generated route requires at least two contributing active routes to be active.
B.A generated route has a route preference of 150.
C.The primary contributing route is the route with the lowest preference that falls within the aggregate range of prefixes.
D.A generated route receives the next hop for the primary contributing route.
Correct Answer: CD
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 285
Which three statements are correct about VRRP? (Choose three.)
A.It requires speakers to be configured with BFD.
B.It uses a virtual router MAC address for LAN communications.
C.It uses multicast address 224.0.0.18.
D.It is confined to the local network with a TTL of 255.
E.It uses the virtual router's lo0 address for LAN communications.
Correct Answer: BCD
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 286
Click the Exhibit button.
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
Which statement is true regarding the output shown in the exhibit?
A.The configuration supports IPv4 multicast routes.
B.The configuration supports IPv4 unicast routes.
C.The configuration supports IPv6 unicast routes.
D.The configuration supports IPv6 multicast routes.
Correct Answer: C
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 287
You are asked to configure a GRE tunnel between two remote sites to support the exchange of IPv6 traffic. The two sites are separated by an IPv4 network.
Which two configuration elements are required? (Choose two.)
A.You must enable the GRE interface for IPv6 operations.
B.You must increase the MTU to no less than 2500.
C.You must add a static route for the remote IPv6 destination subnet with the remote tunnel endpoint as the next hop at each site.
D.You must enable the GRE interface for IPv4 operations.
Correct Answer: CD
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 288
What does an STP BPDU Port ID field contain?
A.bridge priority
B.bridge port priority and bridge port address
C.bridge priority and bridge address
D.port priority and port address
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
Correct Answer: D
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 289
Which two BGP attributes are mandatory? (Choose two.)
A.next hop
B.aggregator
C.AS path
D.community
Correct Answer: AC
Section: Volume C
Explanation
Explanation/Reference:
QUESTION 290
Click the Exhibit button.
Which aggregate route would represent all four routes shown in the exhibit?
A.10.10.0.0/19
B.10.10.0.0/21
C.10.10.0.0/20
D.10.10.0.0/22
Correct Answer: A
Section: Volume C
Explanation
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications
Explanation/Reference:
QUESTION 291
You are asked to configure an MC-LAG, in active-active mode, between PE1 and PE2. Which configuration is correct?
www.vceplus.com - Download A+ VCE (latest) free Open VCE Exams - VCE to PDF Converter - VCE Exam Simulator - VCE Online - IT Certifications